Long Spans Without Laps
The structural reason this profile suits aviation is length. On-site forming produces runs over 100 m, so a hangar roof has no transverse lap in the high-suction zone - the place a lap would otherwise be the first failure.
- 65 mm rib, 430 mm effective cover, custom width 200–700 mm
- Panel formed on site: over 100 m continuous, no transverse joint
- Positive and negative arc from 3 m radius; tapered panels 230–600 mm
- Purlins and seam spacing set from the uplift calculation, not a default

Coating For The Exhaust Environment
Aviation fuel vapour, glycol and wash-down chemicals attack different coatings differently. PVDF fluorocarbon is the baseline; where the project specifies it, an aluminium substrate removes the rust question entirely.
|
Exposure |
Recommended build |
Why |
|
Jet exhaust, general |
PVDF on AZ150 steel |
Colour and gloss retention |
|
Wash-down chemicals |
PVDF on aluminium |
No ferrous substrate to corrode |
|
Coastal + aviation |
PVDF on aluminium, 1.0 mm |
Two aggressions at once |
Programme And Access
A hangar is usually built around an operating apron, so the roof is installed in phases. Panel runs are planned to break at structural bays, the crane plan is agreed before the first lift, and the take-off is split by phase so each delivery lands where it is used.
Evidence
- Panel run plan: >100 m on-site forming, no transverse lap
- Uplift calculation basis for the edge and corner zones
- Coating data sheet matched to the exposure list
- Aviation reference project with phase-by-phase photos
FAQ
Q1. What span can a single panel run cover?
Over 100 m when formed on site; the run is planned around structural bays.
Q2. Which coating for fuel vapour?
PVDF fluorocarbon as baseline; aluminium substrate where wash-down chemicals are also present.
Q3. Can you work in phases around operations?
Yes - panel runs, deliveries and lifts are split by bay and by phase.
Q4. Do you supply the uplift calculation?
The seam and purlin spacing are set from it, and the basis is issued with the drawing set.

Send Span + Exposure for Plan
Send the hangar span, the wind zone and the exposure list; we return the run plan, coating build and uplift-based seam spacing.
Hot Tags: hangar metal roofing, China hangar metal roofing suppliers, factory

