Concealed Fastener Metal Roof Panels
video
Concealed Fastener Metal Roof Panels

Concealed Fastener Metal Roof Panels

Most first-time metal buyers ask the wrong first question — they ask for a price before deciding between concealed and exposed fixing. This page exists to settle that decision in four questions, so the quote you receive is for the roof you actually need. Concealed fastener metal roof panels are the answer for roughly two thirds of the enquiries we receive; the rest are better served by a screw-fixed roof.

Four Questions, One Decision

 

Answer these before requesting a price:

1. Is the roof visible from the street or below? Visible → concealed, because there is nothing to rust or streak

2. What is the design wind uplift at the edge zone? High → concealed with a mechanical or pressed seam

3. Will anyone walk on it? Regular traffic → a seam that tolerates it

4. What is the holding plan? Short-term or temporary → exposed fixing is honest economics

 

How Concealed Fixing Actually Seals

 

The fastener does not penetrate the weather surface. The hanger sits under the panel, the rib closes over it, and water runs in the channel between ribs. That is the whole principle - no sealant bead is doing the work, which is why the detail survives thermal cycling that would open a mastic joint.

  • 35 mm rib, 300–700 mm adjustable width, 380 mm recommended
  • Unlimited panel length: no transverse lap, no lap leak
  • Built-in expansion gap inside the lock
  • 304 stainless hangers and screws on the concealed path

4

 

Five Mistakes We See On First Installations

 

Every one of these is avoidable with the drawing open:

  • Cutting the panel without re-sealing the cut edge
  • Fixing the hanger off the rib line, then forcing the seam closed
  • Skipping the expansion gap at the run end
  • Installing up-slope instead of down-slope at a change of pitch
  • Leaving the eave closure until after the gutter

 

Evidence

 

  • Concealed vs exposed decision table
  • Seam cross-section at the hanger position
  • Installation sequence sheet, one page
  • Five-error checklist for site handover

 

FAQ

 

Q1. Concealed or exposed?

Visible roof or high uplift → concealed; short holding period and tight budget → exposed.

Q2. Is sealant doing the waterproofing?

No - the sealed path is structural; the rib closes over the fixing.

Q3. How wide are the panels?

300–700 mm adjustable, 380 mm recommended.

Q4. What length can I order?

Unlimited in production; shipping and handling set the practical limit.

 

modular-1
Send Answers for Recommendation

Work through the four questions and send the answers; we return the fixing recommendation and a panel schedule matched to it.

 

Hot Tags: concealed fastener metal roof panels, China concealed fastener metal roof panels suppliers, factory

Send Inquiry