25-430 Or 35-410: Choosing The Rib
The catalogue carries two standard models, and the choice is a design decision, not an upsell:
- 25 mm rib: lighter visual line, the better choice for curved, fan and polyline panels
- 35 mm rib: more section depth for medium spans and higher wind load
- Batten spacing: ≤600 mm recommended
- Minimum roof pitch: 5°; drainage path, gutter and seam design work together
|
Model |
Rib height |
Effective cover |
|
25-430 (the common width for pitched roofs) |
25 mm |
430 mm |
|
35-410 |
35 mm |
410 mm |

Single Or Double Interlock - Both Documented
Both seam options are produced on the same line, so the specification can follow the wind zone rather than a stock list. Single interlock for standard residential and commercial pitches; double interlock where the project engineer wants a second mechanical fold at the seam. Every panel leaves with no nail holes - the fixing sits inside the seam, which is why the surface has nothing to rust from.
- Straight, curved, fan and polyline panels from the same drawing set.
- Custom lengths to reduce site joints.
- PVDF fluorocarbon finish on AZ150 steel (0.5–0.8 mm) or aluminium-magnesium-manganese (0.8–1.0 mm).
- Substrate and coating named on the drawing, so the sheet can be checked on arrival.

What The Package Contains
Panels are half a roof. The other half is the edge work, and it is quoted with the job:
1. Eave, rake, ridge and hip flashings cut to the same drawing
2. Batten and clip schedule at ≤600 mm spacing
3. Sealant and closure set per node detail
4. Loading plan per container, indexed to the take-off






Evidence
- Rib, cover and thickness sheet for both models (25-430 / 35-410).
- Substrate statement on the drawing: AZ150 steel or aluminium-magnesium-manganese, thickness named.
- Curved, fan and polyline sample photos from delivered projects.
- Coating system on the drawing: substrate, pre-treatment, primer and top coat.




FAQ
Q1. Why two models?
25 mm rib suits curved and lightweight roofs; 35 mm rib adds section depth for medium spans and stronger wind load.
Q2. What thicknesses are available?
AZ150 steel 0.5–0.8 mm; aluminium-magnesium-manganese 0.8–1.0 mm.
Q3. What is the minimum pitch?
5°. Below that we recommend a different system, and we will say so.
Q4. Can panels follow a curved roof?
Yes - straight, curved, fan and polyline panels are all produced from the same drawing.

Send Drawing for Model Selection
Send the roof geometry and wind zone, and we return the model choice (25-430 or 35-410), the batten schedule and the flashing list against your drawing.
Hot Tags: standing seam metal roofing systems, China standing seam metal roofing systems suppliers, factory

